Manufacturer: | Scratch |
I saw this bottle at the store where I work and just knew it had "rocket" written all over it!
Parts List:
I cut the coupler into two parts: a 2-inch piece to assemble the body tubes together and a 1-inch piece to attach to the bottle "cap" nose. Then I cut the bottom of the bottle to accommodate the cardboard tube. The motor tubes were inserted into the centering rings and left to dry.
The short coupler was epoxied into the bottom of the bottle cap and the coin slot sealed with epoxy. A short length of Kevlar® string formed into a loop to hold the shock cord was added at this time. A similar loop was epoxied into the top of the body tube.
When the motor assembly was dry, I fit it inside the body tube and let it dry. This whole assembly was then inserted into the plastic bottle and epoxied at the bottem and neck areas.
Slots for the fins were carefully cut into the plastic bottle to accommodate the thru the wall to motor mount fins. The fins were then epoxied into place, making sure two of the fins 'framed' the front label. The shock cord and parachute were installed. Two 1/2" long 1/4" lugs were added between to fins toward the back of the bottle.
A flight on four D12's indicated the rocket is stable, even though only two motors lit.
Sponsored Ads