× We have recently moved to a new server. If you run into any issues, please let us know through the Contact Us link at the bottom of the page. Thanks for visiting RocketReviews.

All Rocketry Blogs

Sport Rocketry / Rocketry Products / Estes / Kits / Orange Bullet

     Rocketry Product: Estes - Orange Bullet {Kit} (7295) [2020-]

    Model Rocket Building: Estes New Kit Poster (2019-10-17)
    From TRF, CoModelBuilder showed a poster featuring the upcoming Estes kits: The Orange Bullet is small with tumble/featherweight recovery. Enlarge the picture and you can see the weights on ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 1, Parts (2020-04-25)
    The back side of the face card tells the story. I would assume more "Designer Signature Series" kits are in the works. Parts are good quality. Parts re few, typical of a small featherweight recovery ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 2, Fin Fairings (2020-04-26)
    The original fairings were called "Body Ribs". I don't know why they were part of the design, maybe to keep the nose cone on at ejection. The nose cone shoulder was short! The fairings have a taper ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 3, Fin Fairings (2020-04-27)
    The fairings are glued on the body tube. I used my aluminum angle to be sure they are on straight. The side view shows a gap along the sides from the curvature of the tube. Normally I would sand a ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 5, Ends & Edges (2020-04-29)
    Here's the model glued together with the launch lug. I didn't like the nose cone joint seam. I went back, filled then primer/filled it. Probably not needed as the black bar decal would cover most of ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 7, Decals (2020-05-01)
    Here's the little sheet of black water slide decals. I don't know why the three black bands weren't wide enough to fill the areas between the fin fairings. I guess it was a good idea to fill the ... [Read More]

    Model Rocket Building: Old Estes Plan - The Orange Bullet (2011-03-24)
    I came across this plan on the Shasta Plan site and on a publication for sale on Ebay . You can follow the Ebay auction of the 1960 Estes publication: "Model Rocketry" HERE You can see the entire ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Background (2020-04-24)
    In March of 2011, I did a post about finding the plans for the Estes Orange Bullet. Here's the post from 2011 -  CLICK HERE Estes is releasing a new kit version of the Orange Bullet under the ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 4, Nose Cone (2020-04-28)
    I did as much prepping as I could while the nose cone was being sent out. The main body got a white undercoat and smooth sanding. I probably should have waited, this involved more tight filling than ... [Read More]

    Model Rocket Building: Estes Orange Bullet #7295, Part 6, Fin Tip Weights (2020-04-30)
    Set the nose "weights" on first without glue. Notice there is a very small angle cut into one corner. This fits against the trailing edge of the fins. There are two sides to the weight pieces. The ... [Read More]